Ryobi P21100VNM Operation Manual - Page 9
Warning
![]() |
View all Ryobi P21100VNM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
OPERATION WARNING: Verify that all guards and tubes are in place prior to use. If the blower is dropped, stop blower and verify that no damage has occurred. If any guard, part, or tube is damaged or missing, do not use blower until it has been repaired or replaced by a qualified service center. Use of blower with damaged or missing guards, parts, or tubes can result in serious personal injury or further damage to the blower. NOTICE: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installation of the battery pack can cause damage to internal c omponents. To remove: Depress the latches on the battery pack and remove from the blower. NOTICE: Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please contact customer service or an authorized service center for assistance. APPLICATIONS You may use this product for the purposes listed below: Clearing leaves and other debris from your lawn Keeping decks and driveways free from grass clippings, leaves, pine needles, and other debris TO INSTALL / REMOVE BATTERY PACK See Figure 3. WARNING: Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. To install: Insert the battery pack into the product as shown. WARNING: Make sure the latches on each side of the battery pack snap in place and the battery pack is fully seated and secure in the battery port before beginning operation. Failure to securely seat the battery pack could cause the battery pack to fall out, resulting in serious personal injury. WARNING: Battery tools are always in operating condition. Therefore, switch should always be locked with hands free of the lock-out button when not in use. Remove battery pack when transporting or carrying blower to avoid accidental starting, which may result in serious injury. For complete charging instructions, refer to the Operator's Manuals for your RYOBI battery pack and charger models. STARTING/STOPPING THE BLOWER See Figure 4. To start the blower, depress the switch trigger. To stop the blower, release the switch trigger. USING TURBO BOOST See Figure 4. While the switch trigger is depressed, press the turbo boost button to increase the air flow to the maximum velocity. NOTE: The blower will return to normal speed when the button is released. OPERATING THE BLOWER See Figure 5. n To keep from scattering debris, blow around the outer edges of a debris pile. Never blow directly into the center of a pile. n To reduce sound levels, limit the number of pieces of equipment used at any one time. n Use rakes and brooms to loosen debris before blowing. In dusty conditions, slightly dampen surfaces when water is available. n Conserve water by using power blowers instead of hoses for many lawn and garden applications, including areas such as gutters, screens, patios, grills, porches, and gardens. 7 - English
![](/manual_guide/products/ryobi-p21100vnm-operation-manual-32072ff/9.png)