Ryobi P2840 Operation Manual 1

18V BACKPACK CHEMICAL

SPRAYER

PULVÉRISATEUR DE PRODUITS

CHIMIQUES DORSAL 18 V

ROCIADOR DE SUSTANCIAS

QUÍMICAS CON MOCHILA DE 18 V

P2804

NOTE:

These instructions replace the

REPLACING SEALS

instruc-

tions located on page 11 in your operator’s manual.

WARNING:

This insert sheet is not a substitute for reading the operator’s

manual. To reduce the risk of injury or death, user must read and

understand operator’s manual before using this product. All page

references refer to the operator’s manual.

REPLACING SEALS

See Figure 1.

WARNING:

Always follow procedures for draining and cleaning the tank

before replacing the seals. Make sure you wear rubber gloves

when reaching into the chemical tank. Wash your hands thor-

oughly afterwards. Failure to follow these instructions can result

in a rash, skin irritation, or other serious personal injury if you

directly contact some chemicals.

Fig. 1

995000503

12-1-17 (REV:01)

Over time, seals can harden and crack, which can allow the chemical

sprayer to leak. A set of replacement seals is included. Refer to the

image shown for the location of each of the seals, then replace as

needed to address any leaks that develop.

Additional sets of replacement seals can be ordered by contacting

customer service.

NOTE:

Unthreading the connections to replace the seals could allow

liquid to escape, so always clean the chemical sprayer thoroughly

as previously described before replacing the seals.