Ryobi P2840 Operation Manual 1 - Page 1

Ryobi P2840 Manual

Page 1 highlights

18V BACKPACK CHEMICAL SPRAYER PULVÉRISATEUR DE PRODUITS CHIMIQUES DORSAL 18 V ROCIADOR DE SUSTANCIAS QUÍMICAS CON MOCHILA DE 18 V P2804 NOTE: These instructions replace the REPLACING SEALS instructions located on page 11 in your operator's manual. Over time, seals can harden and crack, which can allow the chemical sprayer to leak. A set of replacement seals is included. Refer to the image shown for the location of each of the seals, then replace as needed to address any leaks that develop. Additional sets of replacement seals can be ordered by contacting customer service. NOTE: Unthreading the connections to replace the seals could allow liquid to escape, so always clean the chemical sprayer thoroughly as previously described before replacing the seals. WARNING: This insert sheet is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to the operator's manual. Fig. 1 REPLACING SEALS See Figure 1. WARNING: Always follow procedures for draining and cleaning the tank before replacing the seals. Make sure you wear rubber gloves when reaching into the chemical tank. Wash your hands thoroughly afterwards. Failure to follow these instructions can result in a rash, skin irritation, or other serious personal injury if you directly contact some chemicals. 995000503 12-1-17 (REV:01)

  • 1
  • 2

18V BACKPACK CHEMICAL
SPRAYER
PULVÉRISATEUR DE PRODUITS
CHIMIQUES DORSAL 18 V
ROCIADOR DE SUSTANCIAS
QUÍMICAS CON MOCHILA DE 18 V
P2804
NOTE:
These instructions replace the
REPLACING SEALS
instruc-
tions located on page 11 in your operator’s manual.
WARNING:
This insert sheet is not a substitute for reading the operator’s
manual. To reduce the risk of injury or death, user must read and
understand operator’s manual before using this product. All page
references refer to the operator’s manual.
REPLACING SEALS
See Figure 1.
WARNING:
Always follow procedures for draining and cleaning the tank
before replacing the seals. Make sure you wear rubber gloves
when reaching into the chemical tank. Wash your hands thor-
oughly afterwards. Failure to follow these instructions can result
in a rash, skin irritation, or other serious personal injury if you
directly contact some chemicals.
Fig. 1
995000503
12-1-17 (REV:01)
Over time, seals can harden and crack, which can allow the chemical
sprayer to leak. A set of replacement seals is included. Refer to the
image shown for the location of each of the seals, then replace as
needed to address any leaks that develop.
Additional sets of replacement seals can be ordered by contacting
customer service.
NOTE:
Unthreading the connections to replace the seals could allow
liquid to escape, so always clean the chemical sprayer thoroughly
as previously described before replacing the seals.