Ryobi P3200 English Manual - Page 11

OPERATION TO INSTALL BATTERY PACK See Figures 3 - 4.  Place the power switch in the OFF ( O ) position. ( I )  Place the battery pack in the canister vac. ON  Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the canister vac before beginning operation. ( O ) OFF I TO REMOVE BATTERY PACK See Figures 3 - 4. POWER SWITCH � Place the power switch in the OFF ( O ) position.  Locate latches on side of battery pack and depress both sides to release battery pack. � Remove battery pack from the canister vac. Fig. 4 WARNING: Battery tools are always in operating condition. Therefore, switch should always be in the OFF ( O ) position when not in use or carrying at your side. HOSE ATTACHMENT See Figure 5.  To attach the hose, push tapered end of hose into opening of the vacuum port.  To remove the hose, hold the tapered end and pull hose from vacuum port. USING THE ATTACHMENTS See Figure 6. Vacuuming can be performed with either the hose or the vacuum attachments.  Turn off the canister vac.  Insert the attachment into the front end of the hose, making sure the attachment is firmly in place.  To remove, hold the attachment and pull from hose. The vacuum attachments are designed for the following applications:  The wide nozzle with squeegee is used to vacuum large, flat, dry or wet surfaces.  The floor brush is used to vacuum carpeted surfaces.  The wand is used as a handle in vac mode and as a blower tube in blower mode. The wand can also function as an extension to any of the canister vac attachments.  The car nozzle is used for car interiors or for vacuuming small surface areas. The car nozzle can also be used with the wand while the canister vac is in blower mode for widened air flow.  The narrow crevice tool is used to vacuum narrow, hard to reach places. 11 HOSE VACUUM PORT WAND R WIDE NOZZLE WITH SQUEEGEE Fig. 5 CAR NOZZLE NARROW CREVICE TOOL FLOOR BRUSH Fig. 6