Ryobi P330 User Manual - Page 7
Maintenance, Troubleshooting
View all Ryobi P330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts can create a hazard or cause product damage. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. APPLICATION AND BUFFING/POLISHING BONNETS Both the application and buffing/polishing bonnets are reusable. For maximum life and performance, hand wash after use and allow them to air dry. If needed, the bonnets can be machine washed in cold water with a small amount of detergent, then machine dried using low heat. FOAM PAD It is important that the pad retain its original shape and dimensions. Allow it to dry completely after each use. Make sure to remove the bonnets, wash them, and store separately. Polisher should be stored with the pad facing up in order to extend pad life and retain its shape. Be careful not to use too much polish at one time. If the pad becomes saturated, it will not last as long. TROUBLESHOOTING Problem Possible Cause Solution Wax does not go on evenly. Too much wax on the bonnet. Remove a portion of the wax and retry. Polishing seems difficult. Bonnet may be worn. Replace bonnet. Polisher does not turn on. Battery is not charged. Problem with motor. Charge battery Call authorized service center. Pad spins slower than normal or not Motor needs to be serviced or replaced. Call authorized service center. at all. NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER FRENCH AND SPANISH LANGUAGE SECTIONS. This product has a Three-year Limited Warranty. For Warranty details go to www.ryobitools.com 7 - English