Ryobi P3520 Operation Manual - Page 6

OPERATION To install battery pack:  To release each of the four latches, press the latch lock. Lift the latch and pull upward. This will release the latch catch.  Release all four latches in this manner to open the speaker and lift off the dome.  If any fluid enters the sealed battery compartment when opening, thoroughly dry the interiors of the sealed compartment, upper dome, and base before installing the battery pack and closing the battery compartment.  Place the battery pack into the battery port, aligning the rib on the battery pack with the groove in the battery port.  Make sure the latches on the battery pack snap into place and the battery pack is secured to the product before reassembling the speaker.  To reassemble, place the upper dome on top of the base, aligning the latches on the speaker's base with the lock brackets.  For each latch, hook the latch catch over the lip on the upper dome. Push down on the latch until it snaps into the closed position.  Make sure all four of the latches are securely locked. There must be no gaps or movement between the dome and the base. To remove battery pack:  Place the base on a stable surface with the dome and controls facing up.  Release the four latches as described above to remove the housing from the base of the product.  Depress the latches on both sides of the battery pack to release it. NOTE: Always remove battery pack when not in use. Leaving the battery pack connected for long periods of time may drain the battery pack. CONNECTING THE SPEAKER TO BLUETOOTH® WARNING: Never handle electrical devices that you are trying to connect to the BLUETOOTH® speaker while you are wet, in a swimming pool, or standing on wet ground. Handling electrical devices can result in death by electrocution or electric shock. The floating pool speaker provides wireless connectivity to most audio-capable mobile devices, MP3 players, etc., via BLUETOOTH® wireless technology. For complete operating instructions for all external devices, always refer to the manual that was included with the device you wish to use. MODE MUSIC AND LED LIGHT SHOW MUSIC ONLY LIGHTS ONLY OFF ICON MUSIC/LIGHT SHOW Press the power button. The product The blue LED lights turn on and will slowly searches for a BLUETOOTH® device increase and decrease in intensity until mu- with which to pair. sic is selected on your device. (See Connecting the Speaker to BLUETOOTH®) When paired to a device, music can be When the volume is increased or de- selected and volume can be controlled creased, the LED lights flash and change using Volume Up or Volume Down from pattern in response to the volume and the the control panel. beat of the music. You may also adjust volume using the volume control on your device. Press the light bulb button twice to turn Lights turn off, music is on. off the LED light show. Press the power button to turn music Music is off, lights will be on. Lights will cy- off. cle through the range of colors but will not Press the light bulb button to turn on the flash or change pattern. LED lights. Press the light bulb button again to turn all functions off. 6 - English