Ryobi P410 English Manual - Page 11
Charging A Hot Battery Pack, Warning, Turning The Sander On I /off O
View all Ryobi P410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATION CHARGING A HOT BATTERY PACK When using the product continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Authorized Service Center for checking or replacing. NOTE: This situation only occurs when continuous use of the product causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batteries. If the charger does not charge the battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check. WARNING: Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. TURNING THE SANDER ON ( I )/OFF ( O ) See Figure 3. Install the battery pack. To turn ON the sander: push the ON ( I )/OFF ( O ) switch to the ( I ) position. To turn OFF the sander: push the ON ( I )/OFF ( O ) switch to the ( O ) position. P100 BATTERY PACK P110 CHARGER YELLOW LED RED LED GREEN LED Fig. 2 ON ( I ) / OFF ( O ) SWITCH ON ( I ) OFF ( O ) Fig. 3 11