Ryobi P715 English Manual - Page 8

MAINTENANCE WARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause product damage. WARNING: To avoid serious personal injury, always remove the battery pack from the product when cleaning or performing any maintenance. GENERAL MAINTENANCE Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc. WARNING: Do not at any time let brake fluids, gasoline, petroleumbased products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury. Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at an Authorized Service Center. REPLACING BULBS See Figures 5 - 7. Over time, the bulb will burn out. When this occurs, replacing the bulb will be necessary. Be careful not to touch the bulb glass. This will reduce the life of the bulb. To replace a bulb:  Remove battery from the spotlight and let it cool for at least 5 minutes.  Turn the bezel counterclockwise to remove.  Remove the reflector assembly from the spotlight housing. Do not pull on the leads connected to the assembly.  Remove the white connection point from its nest in the housing.  Remove the white connection terminal from its connection point. NOTE: Do not pull white lead without holding the connection point, as this may damage lead.  Remove the retainer pin from the reflector and remove bulb assembly. Bulb assembly may be rotated in reflector if needed to aid in removal.  Install new bulb assembly.  Replace bulb retainer pin.  Hold white connection terminal and reconnect white lead.  Return the white connection point to its nest.  Align tabs on each side of lens seal with notches on spotlight housing and seat lens seal in place.  Reattach bezel carefully by rotating clockwise.  Tighten securely. NOTE: Always ask for replacement bulb H3 6V55W, number 019020001007. TO REMOVE LENS SEAL REFLECTOR LENS TO REPLACE BEZEL TABS GROOVE NOTCHES RIDGE REFLECTOR ASSEMBLY Fig. 5 REFLECTOR ASSEMBLY WHITE CONNECTION CONNECTION POINT TERMINAL RETAINER PIN RED CIRCUIT LEAD CONNECTION POINT NEST Fig. 6