Ryobi P724 Operation Manual - Page 5

ASSEMBLY WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always remove battery pack from the tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the following purpose:  Light-duty vacuuming of dry surfaces  Household type INSTALLING/REMOVING BATTERY PACK See Figures 1 - 2, page 8.  Place the battery pack in the stick vacuum. Align the raised rib on the battery pack with groove in stick vacuum's battery port.  Make sure the latches on each side of the battery pack snap into place and that the battery pack is secured in the stick vacuum before beginning operation.  Locate the latches on the side of the battery pack and depress both sides to release the battery pack from the stick vacuum. NOTE: It is not necessary to remove the battery pack from the tool to recharge.  With the battery installed, place the tool on the wall- mounted charger by aligning the raised ribs on the tool housing with the grooves on the charger.  Slide the tool down until it is fully seated on the charger. NOTE: The green LED indicator will flash quickly to evaluate, intermittently while charging, and will fade in and out when fully charged. STARTING/STOPPING THE VACUUM See Figure 3, page 8. To start the vacuum:  Press the ON/OFF trigger once to start the vacuum and the LED indicator illuminates blue. To stop the vacuum:  Press the ON/OFF trigger again. HIGH/LOW SWITCH See Figure 3, page 8. The vacuum has two speeds to accommodate your cleaning needs. NOTE: The vacuum always starts in high speed.  Press the ON/OFF trigger once to start the vacuum in HIGH speed and the LED indicator illuminates blue.  Press the HIGH/LOW switch for LOW speed and the LED indicator illuminates green. NOTE: Pressing the HIGH/LOW/ switch repeatedly will toggle the vacuum between the two speeds. 5 - English