Ryobi P782 Operation Manual - Page 8
Operation
View all Ryobi P782 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
OPERATION SET UP See Figures 1 - 6, pages 10 - 11. NOTE: The product is shipped with the extension tubes retracted, the legs folded in, and the adjustable head tilted down. Follow the instructions below to raise the product to the operating position. Insert the feet into the holes of each leg. Move the legs back and away from the base. Position the product on its base and legs. Push the release button and rotate the head upward until it clicks into place. WARNING: When adjusting the height of the product, hold the upper, middle, or lower tube with one hand and unlock the clamp with the other. If not held properly, the top portion of the product could descend rapidly and cause serious personal injury or property damage. Unlock the clamp securing the lower tube and raise it to your desired height. Lock the tube in place. Repeat the process to extend the middle and upper tubes. Lock the tubes in place. NOTE: Raise the upper tube gradually. Do not extend the product beyond a stable height. WARNING: Keep everyone - helpers, bystanders, children, and animals-a safe distance from an extended product. Serious personal injury or property damage could occur if the tool is tipped. Unless you are adjusting the product, keep a minimum distance of 5 ft. away from the unit. To lower the product, reverse the steps listed above. INSTALLING/REMOVING BATTERY PACK See Figure 7, page 11. Insert the battery pack into the product as shown. Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation. Depress the latches to remove the battery pack. For complete charging instructions, see the operator's manuals for your battery pack and charger. WARNING: Always remove battery pack or unplug extension cord from your product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack or unplugging extension cord will prevent accidental starting that could cause serious personal injury. INSTALLING/REMOVING POWER CORD See Figure 8, page 11. WARNING: Do not route cord under carpets, rugs, runners, furniture, or appliances and always route cord away from traffic areas to prevent a tripping hazard. Remove the battery pack. Insert the female end of the power cord into the product as shown. Connect the male end of the power cord to the power source. Make sure the power cord is secured before beginning operation. 8 - English