Ryobi P796B 18V Area Light - Page 4

FEATURES PRODUCT SPECIFICATIONS Input 18V DC Maximum Light Output 400 Lumens in High mode OPERATION WARNING: Do not direct the light beam at persons or animals and do not stare into the light beam yourself (not even from a distance). Staring into the light beam may result in serious injury or vision loss. WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. POWER BUTTON (HIGH/MEDIUM/LOW/OFF) See Figure 2, page 6.  Connect the product to the battery pack.  Press and release the power button to cycle between HIGH, MEDIUM, LOW, and OFF.  Press and hold the button for two seconds while ON (in any mode) and the light will shut off.  Press and hold the button for two seconds while OFF allows the light to go into LOW mode. HANGING THE LED AREA LIGHT See Figure 3, page 6. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this tool for the purpose listed below:  General illumination of most work area spaces INSTALLING/REMOVING BATTERY PACK See Figure 1, page 6.  Insert the battery pack into the product as shown.  Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation.  Depress the latches to remove the battery pack. For complete charging instructions, refer to the Operator's Manuals for your battery pack and charger models. WARNING: Only hang or mount LED area light in an area where no electrical wires, utility cables, pipes, or other obstructions are located. Contact your local utility company or a qualified electrician if you are unsure. Do not hang area light from any electrical power cord. Ensure area light is securely installed to prevent falling object hazard. Failure to follow these instructions can result in electrocution, electrical shock, or other serious personal injury.  Install a clip or a lanyard to one of the light's brackets for hanging. NOTICE: Do not attach anything other than the battery pack to the area light when it is hanging.  Be careful not to hang the area light in a position that prevents normal operation of the light. 4 - English