Ryobi P815 Trilingual (P206) - Page 9

5 OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. BATTERY PACK WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury. LATCHES APPLICATIONS You may use this tool for the purposes listed below:  Drilling in wood  Drilling in ceramics, plastics, fiberglass, and laminates  Drilling in metals  Mixing paint This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manual for the battery packs and chargers listed in the General Safety Rules. TO INSTALL BATTERY PACK See Figure 2.  Place the direction of rotation selector in center ­position.  Place the battery pack in the drill. Align raised rib on bat- tery pack with groove in drill's battery port.  Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in drill before beginning operation. DEPRESS LATCHES TO RELEASE BATTERY PACK Fig. 2 TO REMOVE BATTERY PACK  Place the direction of rotation selector in center ­position.  Locate latches on side of battery pack and depress both sides to release battery pack from the drill.  Remove battery pack from the drill. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the drill and latches into place properly. Improper installation of the battery pack can cause damage to internal ­components. 9