Ryobi P815 Trilingual (P501) - Page 8
Assembly, Operation - cells
View all Ryobi P815 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ASSEMBLY ATTACHING THE BLADE See Figure 2, page 14. WARNING: A 5-1/2 in. blade is the maximum blade capacity of the saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guard, while thicker blades will prevent blade screw from securing blade on spindle. Either of these situations could result in a serious accident. Remove the battery pack from the saw. n Remove the blade wrench (5 mm hex key) from the stor- age area. n Depress the spindle lock button and remove the blade screw and outer blade washer. NOTE: Turn the blade screw clockwise to remove. CAUTION: To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock. NOTE: Do not run the circular saw with spindle lock engaged. n Wipe a drop of oil onto the inner blade washer and outer blade washer where they contact the blade. WARNING: If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly. n Fit the saw blade inside the lower blade guard and onto the spindle. NOTE: The saw teeth point upward at the front of the saw. n Replace the outer blade washer. n Depress the spindle lock button, then replace the blade screw. Tighten the blade screw securely by turning it counterclockwise. n Return the blade wrench to the storage area. NOTE: Never use a blade that is too thick to allow the outer blade washer to engage with the flats on the spindle. REMOVING THE BLADE See Figure 3, page 14. Remove the battery pack from the saw. n Remove the blade wrench from the storage area. n Position the saw as shown, depress the spindle lock but- ton, and remove the blade screw by turning it clockwise. n Remove the outer blade washer. n Remove the blade. OPERATION WARNING: Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. APPLICATIONS You may use this tool for the following purposes: Cutting all types of wood products (lumber, plywood, paneling) Cross Cutting/Rip Cutting Bevel Cutting Pocket Cutting This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manuals for your Ryobi One+ battery pack and charger models. BATTERY PROTECTION FEATURES Ryobi lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged. INSTALLING THE BATTERY PACK See Figure 4, page 14. n Place the battery pack in the saw. Align the raised rib on the battery pack with the groove inside the saw, then slide the battery pack into the saw. n Make sure the latches on each side of your battery pack snap into place and the battery pack is secured in the saw before beginning operation. 8 - English