Ryobi P850 Trilingual (P204) - Page 7

ASSEMBLY WARNING: Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the product when assembling parts. OPERATION WARNING: Do not allow familiarity with products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below:  Drilling in all types of wood products (lumber, plywood, paneling, composition board, and hard board)  Drilling in ceramics, plastics, fiberglass, and laminates  Drilling in metals This product will accept Ryobi One+ 18 V lithium-ion battery packs and Ryobi One+ 18 V nickel-cadmium battery packs. For complete charging instructions, refer to the Operator's Manual for your Ryobi One+ battery pack and charger models. BATTERY PROTECTION FEATURES Ryobi lithium-ion batteries are designed with features that protect the lithium-ion cells and maximize battery life. If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged. TO INSTALL BATTERY PACK See Figure 2, page 11.  Place the direction of rotation selector in the center ­position.  Insert the battery pack into the product as shown.  Make sure the latches on each side of the battery pack snap in place and that battery pack is secured in the product before beginning operation. WARNING: Always remove battery pack from your tool when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. TO REMOVE BATTERY PACK  Depress the latches on each side of the battery pack.  Remove the battery pack from the drill. WARNING: Battery products are always in operating condition. Therefore, the switch should always be locked when not in use or carrying at your side. SWITCH TRIGGER See Figure 3, page 11. To turn the drill ON, depress the switch trigger. To turn it OFF, release the switch trigger. VARIABLE SPEED The variable speed switch trigger delivers higher speed with increased trigger pressure and lower speed with decreased trigger pressure. Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function. 7 - English