Ryobi P882 User Manual 3 - Page 11
Charging A Hot Battery Pack, Caution, To Remove Battery Pack
View all Ryobi P882 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
OPERATION CHARGING A HOT BATTERY PACK When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Authorized Service Center for checking or replacing. NOTE: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check. TO INSTALL BATTERY PACK See Figure 5. Place the battery pack in the pole pruner. Align the raised rib on the battery pack with groove in pole pruner's battery port. Make sure the latches on each side of the battery pack snap in place and that the battery pack is secured in the pole pruner before beginning operation. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the pole pruner and latches into place properly. Improper installation of the battery pack can cause damage to internal components. TO REMOVE BATTERY PACK See Figure 5. Locate the latches on the side of the battery pack and depress both sides to release the battery pack from the pole pruner. P100 BATTERY PACK P110 CHARGER RED LED GREEN YELLOW LED LED BATTERY PACK Fig. 4 LATCHES Fig. 5 11