Ryobi PCL633B Operation Manual - Page 5

FEATURES PRODUCT SPECIFICATIONS Light Output (High 3,000 Lumens Kelvin Rating 5,000 K ASSEMBLY WARNING: Do not use this product if it is not completely assembled or if any parts appear to be missing or damaged. Use of a product that is not properly and completely assembled or with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. If any parts are damaged or missing, please call 1-800-525-2579 for assistance. OPERATION WARNING: Do not direct the light beam at persons or animals and do not stare into the light beam yourself (not even from a distance). Staring into the light beam may result in serious injury or vision loss. WARNING: Do not allow familiarity with battery products to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. NOTICE: This product is designed to be powered by either a Ryobi™ One+™ 18V battery pack (DC mode) or by 120V wall outlet (AC mode). Either power source can be used by installing an approved battery pack or power cord into the product as described in this manual. APPLICATIONS You may use this product for the purpose listed below:  General illumination of most work area spaces WARNING: Hybrid products are always in operating condition. Therefore, the product should always be in the OFF position, with the battery pack removed and power cord disconnected, when not in use. Do not leave light on while unattended. Failure to follow these instructions could result in serious personal injury. INSTALLING/REMOVING BATTERY PACK See Figure 1, page 8.  Insert the battery pack into the product as shown.  Make sure the latches on each side of the battery pack snap into place and the battery pack is secured before beginning operation.  Depress the latches to remove the battery pack. For complete charging instructions, refer to the Operator's Manuals for your battery pack and charger models. WARNING: Always remove battery pack or disconnect power cord from the product when you are assembling parts, making adjustments, cleaning, or when not in use. Removing battery pack or disconnecting power cord will prevent accidental starting that could cause serious personal injury. 5 - English