Ryobi RY08420 Engine Starting Procedure - Page 1

WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual.To reduce the risk of injury, user must read and understand operator's manual before using this product. ENGINE STARTING PROCEDURE 2.6 oz. 1 GALLON GAS 50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with 1 gallon of fresh gasoline in separate gas container. SHAKE. Pour into fuel tank. Slowly press the primer bulb 10 times. NOTE: After the 10th press, fuel should be visible in the primer bulb. If it is not, continue x10 to press the primer until you see fuel in the bulb. Unlock the cruise control (set to Idle) Set the choke lever to " START" position A. Pull starter grip and rope sharply until engine attemps to run. Do not pull starter grip more than 5 times. Set the choke lever to the " RUN " position B. Pull the starter grip and rope until the engine runs. Do not pull starter grip more than 6 times. NOTE: If engine does not not start, return to the START position A and repeat the steps that follow. Set the choke lever to the " RUN " position B. Lock the cruise control (set to full throttle) Pull starter grip sharply until engine attemps to run. Do not pull starter grip more than 4 times. To Stop: Depress the STOP switch to the stop position "O". 1-800-860-4050 CALL www.ryobitools.com Go to www.ryobitools.com and register your new tool on-line. For any questions about operating or maintaining your product, call the Ryobi® Help Line ! Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator's manual. 990000090 9-27-12 (REV:03)