Ryobi RY141612 Operation Manual - Page 14
Operation
View all Ryobi RY141612 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
OPERATION WARNING: Do not allow familiarity with the product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. WARNING: Never direct a water stream toward people or pets, or any electrical device. Failure to follow these instructions could result in serious injury, electric shock, or death. NOTICE: Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please call customer service or contact an authorized service center for assistance. APPLICATIONS You may use this tool around the house for cleaning most small to large horizontal or vertical exterior surfaces, smaller exterior objects and structures, and outdoor equipment and tools.* You can: n Clean or remove mold and mildew from weathered decks, driveways, patios, walkways, sidewalks, etc. n Remove dirt from various exterior vertical surfaces such as house exteriors, siding, fences, brick, concrete or stone walls, etc. n Wash boats, outdoor furniture, powered or non-powered garden equipment, gutters, window screens, grills, playground equipment, etc. *Always test in an inconspicuous area first. STARTING AND STOPPING THE PRESSURE WASHER See Figure 8. NOTICE: Do not run the pressure washer without water supply connected and turned on, as this may damage the high pressure seals and decrease pump life. Completely unwind the hose from its reel or coil and make sure the hose is not being restricted by tires, rocks, or any other objects that may lessen or prevent water flow to the pressure washer. Before starting the motor: Connect the garden hose. NOTE: Make sure the pressure washer's water intake screen is in place and unclogged before connecting garden hose. Turn on the garden hose then pull the trigger to relieve air pressure; hold the trigger until a steady stream of water appears. NOTE: Make sure the faucet is turned on fully and that there are no kinks or leaks in the hose. To start the motor: With the on/off switch in the OFF position (O), connect the pressure washer to the power supply. NOTE: If using an extension cord, make sure to arrange a drip loop as described on page 3. WARNING: To reduce the risk of electrocution, keep all connections dry and off the ground. Do not touch plug with wet hands. Press the reset button on the pressure washer's plug to make sure the unit is ready for operation. Put the on/off switch in the ON position (I) to start the motor. To stop the motor: Put the on/off switch in the OFF position (O). Pull trigger to release water pressure. NOTE: The pressure washer may be on and the system may have pressure even when the pump and/or motor cannot be heard running. Always use caution around the pressure washer. 10 - English