Ryobi RY1419MT Quick Reference Guide - Page 1

RY1418MT/RY1418MTVN/RY1418MTVNM QUICK REFERENCE GUIDE WARNING: This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to the operator's manual. FIRST TIME ASSEMBLY STARTING THE UNIT 1 Connect the spray wand to the trigger handle (see page 8). 3 Connect the high pressure hose to the pump (see page 9). 1 Connect the pressure washer to the power supply. Press the reset button on the plug to make sure the unit is ready for operation (see page 10). Your pressure washer has been performance tested to ensure high quality standards are met. There may be residual water in the pump. USING DETERGENT 1 Pour pressure washer ­detergent in soap tank (see page 12). 2 Install blue or black soap nozzle (see page 11). 3 Squeeze trigger and wait ­approx. 5 seconds for soap (see page 12). DETERGENT 5 S 2 Connect the high pressure hose to the trigger handle (see page 8). 4 Connect the garden hose to the pressure washer (see page 9). If using an extension cord, arrange a drip loop to avoid the possibility of the tool plug getting wet (see pages 2 and 7). USE ONLY THIS SIZE EXTENSION CORD WHEN USING THIS PRODUCT: Cord Length 25 ft. Wire Size (A.W.G.) 14 50 ft. 100 ft. NOTE: A.W.G. = American Wire Gauge 12 Not Allowed Use of soap nozzle will activate detergent injector at a 20:1 dilution ratio. WARNING! Never use bleach or solvent-based detergent. • Will damage your pump • Will void your warranty • Will damage plants/shrubs NOZZLE SELECTION GUIDE Use the chart below to determine the correct nozzle for your job. HIGH PRESSURE (NO SOAP WHEN USING THESE NOZZLES) LOW ­PRESSURE (FOR SOAP OR GENTLE RINSE) 2 Press switch ON to start the motor (see page 10). SWITCH ON Turbo Nozzle 15º Blue or Black Soap Nozzle Completely uncoil garden hose or remove ­completely from reel to prevent kinks. Turn water faucet on fully. Make sure there are no leaks. With no nozzle installed, squeeze the trigger to relieve air pressure. Hold the trigger until a steady stream of water appears. 3 When finished, press switch OFF to stop the motor (see page 10). SWITCH OFF Concrete, Brick, Masonry   Siding, Gutters, House  Fencing, Deck, Patio  Lawn Equipment, Boat, RV   Recommended Nozzle  Use With Caution for Certain Applications BEFORE STORING THE UNIT 1 Always add Pump Protector to the unit after each use and before storing. This will significantly improve pump life. (See page 12) Pump protector is available from your local retailer. For further assistance, call customer service at 1-800-860-4050. To add, follow the instructions provided by the Pump Protector manufacturer. PUMP PROTECTOR Make the most of your purchase! Go to www.ryobitools.com and register your new tool online. For questions about operating or maintaining your product please call, 1-800-860-4050. 995000735 2-19-19 (REV:03)