Ryobi RY28140 Setup Guide - Page 1

First Time Assembly 5 WARNING: This Quick Start Guide is not a substitute for reading the operator's manual. To reduce the risk of injury, user must read and understand operator's manual before using this product. 1 Remove product from carton. Assemble per instructions in your operator's manual. 6 2 Align and assemble 2 booms until fully seated. 7 3 Spread handle over boom and snap into place. Secure with bolt, washer, and wing nut. 8 Curved Shaft 4 Straight Shaft 9 - OR - Snap shield into place over boom and bracket. Secure with bolt, washer, and wing nut as shown. 10 Mix 2.6 oz. 2-cycle oil with 1 gallon of fresh gasoline in separate gas container. Shake, then pour into trimmer tank. First Time Start 11 Place trimmer on ground with the trim head end facing away from you. 10X Repeatedly press the primer bulb 10 times. 12 trim! Pull quickly and powerfully to start (6x MAX.) Continue to squeeze and hold trigger for 10 seconds after engine starts. If engine does not start, repeat steps 7 10 Set choke lever to B run position. You are now ready to Trim! If engine did not start, repeat steps 7 - 11 Set choke lever to A start position. Squeeze and hold triggers. To stop trimmer, press the red switch located on the top of the trigger housing. Go to www.ryobitools.com and register your new tool online. For any questions about operating or maintaining your product, call the Ryobi® Help Line! 1-800-860-4050 Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator's manual. For additional registration instruction, refer to operator's manual. 990000226 9-13-12 (REV:01)