Ryobi RY34427 User Manual 3 - Page 1
Ryobi RY34427 Manual
View all Ryobi RY34427 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual. To reduce the risk of injury, user must read and understand operator's manual before using this product. ENGINE STARTING PROCEDURE Cold Engine: First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided. 1 Later uses: Check engine lubricant level and add lubricant if needed. LUBRICANT RUN Carefully pour fuel into the tank. Avoid spillage. 2 Immediately replace fuel cap and hand tighten. 1 GALLON GAS Wipe up any fuel spillage. 3 PRIME press the PRIMER BULB 10 times 10x slowly. 4 SET CHOKE lever to " FULL CHOKE " position. Do not squeeze throttle trigger. NOTICE Do not use E15 or E85 fuel (or fuel containing greater than 10% ethanol) in this product. It is a violation of federal law and will damage the unit and void your warranty. HALF CHOKE 4 5 6 FULL CHOKE 3 5 PULL With throttle at idle, starter grip sharply until engine runs. (Max 3 times) • If 60°F or lower, continue to pull starter grip until HALF engine runs. 5 CHOKE • If above 60°F, set CHOKE lever to "HALF CHOKE" and pull starter grip until engine runs. 6 SET RUN After 10 seconds, CHOKE lever to RUN position. Warm Engine: Press the PRIMER BULB 10 times RUN slowly. Set choke lever to RUN. Pull 1 10x starter grip until the engine runs. To Stop: DEPRESS the "STOP" switch to the STOP position 2 4 990000697 8-6-13 (REV:01) 1-800-860-4050 CALL www.ryobitools.com Go to www.ryobitools.com and register your new tool on-line. For any questions about operating or maintaining your product, call the Ryobi® Help Line! Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator's manual. For additional registration instruction, refer to operator's manual.