Ryobi RY34446 Engine Starting Procedure - Page 1

WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual.To reduce the risk of injury, user must read and understand operator's manual before using this product. ENGINE STARTING PROCEDURE Cold Engine: 1 First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided. Later uses: Check engine lubricant level and add lubricant if needed. LUBRICANT RUN 2 Carefully pour fuel into the tank. Avoid spillage. Immediately replace 1 GALLON GAS fuel cap and hand tighten. Wipe up any fuel spillage. PRIME 3 10x press the PRIMER BULB 10 times slowly. 4 SET CHOKE lever to " FULL CHOKE " position. Do not squeeze throttle trigger. NOTICE Do not use E15 or E85 fuel (or fuel containing greater than 10% ethanol) in this product. It is a violation of federal law and will damage the unit and void your warranty. HALF 57 8 CHOKE FULL CHOKE 4 5 PULL With throttle at idle, starter grip sharply until engine runs. (Max 3 times)  If 60°F or lower, continue to pull starter grip until HALF CHOKE engine runs.  If above 60°F, set choke lever to "HALF CHOKE" and 6 pull starter grip until engine runs. SET 6 RUN After 10 seconds, choke lever to RUN position. Warm Engine: RUN 10x To Stop: Press the PRIMER BULB 10 times slowly. Set choke lever to RUN. Pull starter grip until the engine runs. DEPRESS the "STOP" switch to the STOP position 1 2 3 1-800-860-4050 CALL www.ryobitools.com Go to www.ryobitools.com and register your new tool on-line. For any questions about operating or maintaining your product, call the Ryobi® Help Line! Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator's manual. For additional registration instruction, refer to operator's manual. 990000202 5-28-13 (REV:04)