Ryobi RY34446 Starter Guide - Page 1

ADDENDUM 30cc Starting Instructions WARNING: This Addendum is not a substitute for reading the operator's manual. To reduce the risk of injury, user must read and understand operator's manual before using this product. These instructions replace the instructions for Starting and Stopping in the ­Operation section of the operator's manual. STARTING AND STOPPING For Model RY34006, see Operator's Manual Figures 6 - 8. For Models RY34426 and RY34446, see Operator's Manual Figures 8 - 10. Trimmer should be on a flat, bare surface for starting. To start a cold engine:  Slowly press the primer bulb 10 times. NOTE: After the 7th press, fuel should be visible in the primer bulb. If it is not, continue to press the primer until you see fuel in the bulb.  Set the choke lever to the FULL CHOKE position. NOTE: Do not squeeze the throttle trigger.  Pull the starter grip until the engine runs. NOTE: If engine has not started after 3 pulls and:  outside temperature is 60°F or lower, leave the choke in the FULL CHOKE position and continue to pull the starter grip until the engine runs.  outside temperature is above 60°F, move the choke to the HALF CHOKE position and continue to pull the starter grip until the engine runs.  Allow the engine to run for 10 seconds, then set the choke lever to the RUN position. To restart a warm engine:  Slowly press the primer bulb 10 times.  Set the choke lever to the RUN position.  Pull the starter grip until the engine runs. Do not squeeze the throttle trigger. To stop the engine:  To stop the engine, depress the STOP switch to the stop position " ". IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT: Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have. For Help Call: 1-800-860-4050 990000642 5-29-13 (REV:01) TECHTRONIC INDUSTRIES NORTH AMERICA, INC. 1428 Pearman Dairy Road, Anderson, SC 29625 USA 1-800-860-4050 • www.ryobitools.com