Ryobi RY401140US Operation Manual 1 - Page 17

TROUBLESHOOTING IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER. PROBLEM Handle not in position. POSSIBLE CAUSE SOLUTION Handle adjustment pins are not in place. Pull up handle adjustment lever, release, and make sure handle adjustment pins lock into place. Mower not starting. Battery is low in charge. Charge the battery. Start key not installed. Install start key. Handle assembly is not in operating Raise lower and upper handle. position. Mower cutting grass unevenly. Mower not mulching properly. Mower hard to push. Lawn is rough or cutting height not set Adjust the cutting height. properly. Wet grass clippings sticking to the un- Wait until the grass dries before m­ owing. derside of the deck. High grass, rear of mower housing and Raise cutting height. blade dragging in heavy grass, or cutting height too low. Mower not bagging properly. Mower vibrating at higher speed. Motor stops while cutting. Cutting height set too low. Grass blocking rear chute of mower. Raise cutting height. Stop the motor, remove start key, and battery. Remove grass catcher bag and remove the blockage. Blade is unbalanced, excessively or Replace the blade. unevenly worn. Bent motor shaft. Stop the motor, remove start key, and battery. Inspect for damage. Have repaired by an authorized service center before restarting. Cutting height set too low. Raise the cutting height. MAKE THE MOST OF YOUR PURCHASE! 1-800-525-2579 Go to http://register.ryobitools.com and register your new tool on-line. Your product has been fully tested prior to shipment to ensure your complete satisfaction. For any questions about operating or maintaining your product, call the RYOBI Help Line! This product has a Five-year Limited Warranty for personal, family, or household use (90 days for business or commercial use). For warranty details, visit www.ryobitools.com or call (toll free) 1-800-525-2579. 13 - English