Ryobi RY40210B User Manual - Page 9
Assembly - model #
View all Ryobi RY40210B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ASSEMBLY INSTALLING AN ATTACHMENT TO THE POWER HEAD See Figure 2. WARNING: Read and understand entire Operator's Manual for each optional attachment used on this power head and follow all warnings and instructions. Failure to follow all instructions could result in electric shock, fire and/or serious personal injury. WARNING: This 40 V power head is designed to be used only with the attachment models that are specified in this Operator's Manual. It is not designed to be used with brush cutters or other attachment models. Use of other attachments could cause serious personal injuries or property damage. WARNING: Never install, remove, or adjust any attachment while power head is running. Failure to stop the motor can cause serious personal injury. Never operate power head without an attachment. This 40 V power head may be used with only the following Ryobi Expand-It attachments: RY15518 Edger RY15519 Blower RY15523 and RY15523A Straight Shaft String Trimmer RY15525 Curved Shaft String Trimmer RY15550 Cultivator The attachment connects to the power head by means of a coupler device. Stop the motor and remove the battery pack. Loosen the knob on the coupler of the power head shaft and remove the end cap from the attachment. Push in the button located on the attachment shaft. Align the button with the guide recess on the power head coupler and slide the two shafts together. Rotate the attachment shaft until the button locks into the positioning hole. NOTE: If the button does not release completely in the positioning hole, the shafts are not locked into place. Slightly rotate from side to side until the button is locked into place. Tighten the knob securely. WARNING: Be certain the knob is fully tightened before operating equipment; check it periodically for tightness during use to avoid serious personal injury. REMOVING THE ATTACHMENT FROM THE POWER HEAD Stop the motor and remove the battery pack. Loosen the knob. Push in the button and twist the shafts to remove and separate ends. ATTACHING THE FRONT HANDLE See Figure 3. Loosen and remove the wing bolt and washer from the handle. Install the handle on the power head shaft in the area indicated by the illustration. Adjust handle up or down, if necessary, to desired operating position. Reinstall the washer and wing bolt. Tighten wing bolt to secure. 7 - English