Ryobi RY48ZTR100 Operation Manual 1 - Page 7
Assembly, Final Preparation
View all Ryobi RY48ZTR100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY INSTALL THE DRIVE LEVERS See Figure 3. Remove the hex head bolts from the drive lever mounting bracket. Align the holes on the drive lever with the holes on the drive lever mounting bracket as shown. Reinstall the bolts and tighten securely. Repeat to install second drive lever. NOTE: Make sure to use the same holes for mounting the drive lever on each side. The levers must be even once installed. INSTALL THE TOWING PLATE See Figure 4. Align the holes in the towing plate with the holes in the rear crossmember. Install two hex head bolts and tighten securely. TOWING PLATE DRIVE LEVER DRIVE LEVER MOUNTING BRACKET HEX HEAD BOLTS HEX HEAD BOLTS Fig. 4 Fig. 3 FINAL PREPARATION CHECK TIRE PRESSURE Check the air pressure in all tires before use. Improper air pressure will affect handling, steering response, traction, tire life, level cutting, and operator comfort. Be sure tires are inflated to the pressure shown below. NOTE: Tire pressure should only be measured or adjusted when tires are cold. Recommended Pressure Front 19 PSI Rear 18 PSI VERIFY MOWER CONDITION Inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until any missing or damaged parts are replaced. WARNING: Check the tire pressure carefully while inflating. Too much air in the tire could cause the tire to burst, causing serious personal injury. 7 - English