Ryobi RY4CCS User Manual 2 - Page 1
Ryobi RY4CCS Manual
View all Ryobi RY4CCS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
WARNING: This Engine Starting Procedure is not a substitute for reading the operator's manual. To reduce the risk of injury, user must read and understand operator's manual before using this product. ENGINE STARTING PROCEDURE Cold Engine: First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole. 1 Later uses: Check engine lubricant level and add lubricant if needed. LUBRICANT Carefully pour fuel into the tank. Avoid spillage. 2 Immediately replace fuel cap and hand tighten. 1 GALLON GAS Wipe up any fuel spillage. 3 PRIME press the PRIMER BULB 10 times 10x slowly. NOTICE Do not use E15 or E85 fuel in this product. It is a violation of federal law and will damage the unit and void your warranty. Only use unleaded gasoline containing up to 10% ethanol. 4 SET CHOKE lever to "FULL CHOKE" position. Squeeze throttle trigger fully through step 6. 5 PULL With throttle fully engaged, starter grip and rope sharply until engine runs. (Max 3 times) • If 60°F or lower, continue to pull starter grip and HALF rope until engine runs. 5 CHOKE • If 60°F or above, set CHOKE lever to "HALF CHOKE" and pull starter grip and rope until engine runs. 6 SET RUN After 10 seconds, CHOKE lever to the RUN position. Warm Engine: Press the PRIMER BULB 10 times RUN slowly. Set choke lever to RUN. Pull 1 10x starter grip and rope until the engine To Stop: runs. DEPRESS the "STOP" switch to the STOP position RUN HALF CHOKE 4 5 6 FULL CHOKE 3 2 4 995000057 9-9-16 (REV:01) 1-800-860-4050 CALL www.ryobitools.com Go to www.ryobitools.com and register your new tool on-line. For any questions about operating or maintaining your product, call the Ryobi® Help Line! Your Product has been fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips are also available in your operator's manual. For additional registration instruction, refer to operator's manual.