Ryobi RY4CSS User Manual - Page 13
Operating The Trimmer, Warning, Ethanol-blended Fuels, Starting And Stopping
View all Ryobi RY4CSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
OPERATION ETHANOL-BLENDED FUELS NOTICE: Do not use E15 or E85 fuel in this product. It is a violation of federal law and will damage the unit and void your warranty. Only use unleaded gasoline containing up to 10% ethanol. NOTE: To improve performance when using oxygenated fuels, we recommend the use of Ethanol Shield 2-cycle lubricant. STARTING AND STOPPING See Figures 7 - 9. Trimmer should be on a flat, bare surface for starting. To start a cold engine: Lay the product on a flat, bare surface. Push the primer bulb approximately ten times. Set the choke lever to FULL CHOKE. Depress lock-out button and squeeze throttle trigger fully and pull starter grip and rope sharply until engine attempts to start (no more than 4x). Set the choke lever to HALF CHOKE. Pull starter grip and rope until engine runs, no more than 6 pulls. Set the choke lever to RUN. NOTE: In cooler environments, additional pulls of the starter grip and rope may be required with the choke lever in the FULL CHOKE position. To start a warm engine: Lay the product on a flat, bare surface. Push the primer bulb up to ten times. Set the choke lever to RUN. Depress lock-out button and squeeze throttle trigger fully, pull the starter cord. NOTE: If the product does not start, repeat the previous steps. To stop the engine: To stop the engine, depress the STOP switch to the stop position " ". IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT: Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have. For Help Call: 1-800-860-4050 OPERATING THE TRIMMER See Figure 10. WARNING: Engine housing can become hot during trimmer operation. Do not rest or place your arm, hand, or any body part against the engine housing during trimmer operation. Only hold the trimmer as shown in Figure 10 with all body parts clear of engine housing. Extended contact with the engine housing can result in burns or other injuries. WARNING: Always position the unit on the operator's right side. The use of the unit on the operator's left side will expose the user to hot surfaces and can result in possible burn injury. WARNING: To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level. Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a comfortable position with the rear handle about hip height. Always operate trimmer in RUN position. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and string head which could cause damage from overheating. If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in lubricant dripping from the muffler. WARNING: Always hold the string trimmer away from the body keeping clearance between the body and the product. Any contact with the housing or string trimmer cutting head can result in burns and/or other serious personal injury. 9 - English