Ryobi RY803111 User Manual - Page 11

ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the product and any accessories from the box. Make sure that all items listed in the packing list are included. NOTE: This tool is heavy. To avoid back injury, lift with your legs, not your back, and get help when needed. WARNING: Do not use this product if any parts on the Packing List are already assembled to your product when you unpack it. Parts on this list are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. n Inspect the tool carefully to make sure no breakage or damage occurred during shipping. n Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool. n If any parts are damaged or missing, please call 1-800-860-4050 for assistance. PACKING LIST Pressure Washer 25 ft. High Pressure Hose Trigger Handle Spray Wand Quick-Connect Nozzles (4) 4-Cycle Engine Lubricant (SAE 30 or SAE 10W30) Disposable Funnel Handle Operator's Manual WARNING: If any parts are damaged or missing do not operate this tool until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. WARNING: To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts. INSTALLING THE HANDLE See Figure 2. CAUTION: Be careful to avoid pinching your fingers or hands when installing the handle onto the frame. n Push and hold the button on the handle as you slide the handle into the holes in the frame. NOTE: Before use, pull the handle up until the lock button snaps through the locking slot to secure the handle in place. CONNECTING THE SPRAY WAND TO THE TRIGGER HANDLE See Figure 3. n Place the threaded end of the spray wand in the connector on the end of the trigger handle. Tighten securely. NOTE: Be careful to avoid cross-threading, which can cause the trigger handle to leak during use. n Turn the connector clockwise until it stops. This secures the spray wand in place. CONNECTING HIGH PRESSURE HOSE TO TRIGGER HANDLE See Figure 4. n Screw the collar on the high pressure hose into the trigger handle inlet coupler by turning the hose collar clockwise. NOTE: Be careful to avoid cross-threading, which can cause the trigger handle to leak during use. n Pull on the hose to be certain it is properly secured. CONNECTING THE HIGH PRESSURE HOSE TO THE PUMP See Figure 5. n Completely uncoil and straighten the high pressure hose to prevent kinks. NOTE: See Using the High Pressure Hose in Operation for more information about using the high pressure hose. n Align the collar on the hose to the threaded outlet on the pump. n Insert the high pressure hose collar onto the threaded outlet. Page 7 - English