Samsung C49RG9 User Manual - Page 43
DisplayPort Ver., HDMI Mode, Source Detection, Key Repeat Time
![]() |
View all Samsung C49RG9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
DisplayPort Ver. Select your DisplayPort version. ――Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications. ――If the monitor (when set to HDMI, DisplayPort1 or DisplayPort2) is in power saving mode or is displaying the message Check the cable connection and the settings of the source device. or power saving mode activates, press the JOG button to display the function-button screen and then select the button to display the On Screen Display (OSD). You can select 1.1, 1.2 or 1.4. ――If setting the DisplayPort Ver. to 1.1, for the bandwidth limitation of the DisplayPort 1.1 protocol, the actual maximum output refreshing rate of the display cards cannot achieve the level of 120 Hz. ――If you select 1.4, the monitor can support up to 5120 x 1440 @ 120 Hz. ――If you use 5120 x 1440 in DisplayPort source, you can't select 1.2. HDMI Mode Select the HDMI mode to use. ――The supportable device and resolution may differ depending on its version. ――When the version is changed, the screen may blink. ――Some high resolutions may not be supported due to the bandwidth limit in HDMI 1.4 protocol while HDMI Mode is set to 1.4 or 2.0. ――When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the device. ――Set HDMI Mode to 1.4 or 2.0 if sound from the connected DVD player is missing. ――This menu is not available when PBP is enabled. Source Detection Select either Auto or Manual as the method to recognize input signal. Key Repeat Time Control the response rate of a button when the button is pressed. Acceleration, 1 sec, or 2 sec can be selected. If No Repeat is selected, a command responds only once when a button is pressed. 43
![](/manual_guide/products/samsung-c49rg9-user-manual-690cc49/43.png)