Samsung CLX-3176 User Manual (ENGLISH) - Page 76
Understanding display messages, Deve Home Sensor
View all Samsung CLX-3176 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
UNDERSTANDING DISPLAY MESSAGES Messages appear on the control panel display to indicate the machine's status or errors. Refer to the tables below to understand the messages' meaning and correct the problem if necessary. Messages and their meanings are listed in alphabetical order. • If the message is not in the table, cycle the power and try the job again. If the problem persists, call for service. • When you call for service, it is very convenient to provide the service representative with the contents of display message. • xxx indicates the media type. MESSAGE MEANING SUGGESTED SOLUTIONS ADC Not Confirm Error A problem has occurred in the ADC in the machine. Turn the power switch off and on. If the problem persists, call for service. Cancel? W Yes X Your machine's memory has become full while trying to store an original into memory. To cancel the fax job, press the OK button to accept Yes. If you want to send those pages that have been successfully stored, press the OK button to accept No. You should send the remaining pages later, when memory is available. [COMM. Error] The machine has a communication problem. Ask the sender to try again. Connection Error Connection with the SMTP server failed. Check the server settings and the network cable. Data Read Fail Check USB Mem. Time expired while reading data. Try again. Data Write Fail Check USB Mem. Storing to the USB memory failed. Check the available USB memory space. Deve Home Sensor Error There is a problem in the fuser unit. Turn the power switch off and on. If the problem persists, call for service. [Document Jam] The loaded original has jammed in the ADF. Clear the jam. (See "Clearing document jams" on page 72.) Door Open The front cover or rear Close the cover until it cover is not securely locks into place. latched. Enter Again You entered an unavailable item. Enter the correct item again. File Format Not Supported The selected file format is not supported. Use the correct file format. 76 _Troubleshooting MESSAGE Group Not Available Install Imaging Unit Install Toner T Invalid Toner T [Incompatible] IP Conflict Line Busy [Line Error] Low Heat Error Cycle Power LSU Motor Error Cycle Power LSU Hsync Error Cycle Power Mail Exceeds Server Support Main Motor Locked MEANING SUGGESTED SOLUTIONS You have tried to select a group location number where only a single location number can be used, such as when adding locations for a Multiple Send operation. Use a speed dial number or dial a number manually using the number keypad. The imaging unit is not installed. Install the imaging unit. The toner cartridge is Install the toner not installed. cartridge. The toner cartridge you have installed is not for your machine. Install the a Samsunggenuine toner cartridge designed for your machine. The machine has received a fax from which is registered as a junk fax. The received fax data will be deleted. Reconfirm junk fax setup. (See "Receiving options" on page 57.) The network IP address you have set is being used by someone else. Check the IP address and reset it if necessary. (See "Setting up the network" on page 25.) The receiving fax machine did not answer or the line is already engaged. Try again after a few minutes. Your machine cannot connect with the receiving fax machine or has lost contact because of a problem with the phone line. Try again. If the problem persists, wait an hour or so for the line to clear and try again. Or, turn the ECM mode on. (See "Sending options" on page 57.) There is a problem in the fuser unit. Turn the power switch off and on. If the problem persists, call for service. A problem has Turn the power switch occurred in the LSU off and on. If the problem (Laser Scanning Unit.) persists, call for service. A problem has Turn the power switch occurred in the LSU off and on. If the problem (Laser Scanning Unit.) persists, call for service. The mail size is larger Divide your mail or than the supported reduce the resolution. size by SMTP server. There is a problem in Open and then close the the main motor. front cover.