Samsung DV365ETBGSF/A1 User Manual Ver.02 (English, French, Spanish) - Page 22
Connecting The Inlet Hose
View all Samsung DV365ETBGSF/A1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
installing your dryer CONNECTING THE INLET HOSE Method1 - Using the Y Connector and Long Hose The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses. 1. Turn off the cold water faucet. 2. If you have a washer water hose attached to the cold water faucet, unscrew and remove the hose. Y-Connector 3. If space permits, attach the brass female end of the "Y"connector to the cold water faucet. Turn by hand until tight. 4. Attach the straight end of the long hose to the "Y' Water Hose connector. Screw on the hose coupling by hand until it is tight. Duct Exhaust 5. Using pliers, tighten the hose coupling with an additional two thirds turn. Do not overtighten. You can damage the coupling. Frame (back) 6. Attach the angled end of the long hose to the fill valve at the bottom of the dryer's rear frame. Screw on the coupling by hand until it is tight. 7. Using pliers, tighten the hose coupling with an additional two thirds turn. Water Hose Do not overtighten. You can damage the coupling. 8. Attach the water hose to the other side of the "Y" connector. Screw on the hose coupling until it is tight. Using pliers, tighten the coupling with an additional two thirds turn. Do not overtighten. You can damage the coupling. 9. Turn the water faucet on. 10. Check for leaks around "Y" connector, faucets, and hoses. Do not overtighten, as it may damage the coupling. 9. Check that the water faucets are on. 10. Check for leaks around "Y" connector, faucets and hoses. 22_ installing your dryer DV365_03064C-03_EN.indd Sec11:22 2013-08-08 4:08:16