Samsung DV520AEP/XAA User Manual (user Manual) (ver.1.0) (English) - Page 13
Mobile Home Installation, Exhausting
![]() |
View all Samsung DV520AEP/XAA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
01 installing your dryer MOBILE HOME INSTALLATION The installation of the dryer in mobile homes must conform to the Manufactured Home Construction and Safety Standard Title 24 CFR, Part 3280 {formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD (Part 280), 1975} for the United States) or CSA Standards Z240 (for Canada). When installing a dryer in a mobile home, provisions for anchoring the dryer to the floor must be made. Locate an area that has adequate fresh air. A minimum of 72 in² (183 cm²) of unobstructed space is required. Call 1-800-SAMSUNG for information on purchasing the Floor Anchoring Kit as an accessory. All mobile home installations must be exhausted to the outside with the exhaust duct termination securely fastened to the mobile home structure, using materials that will not support combustion. The exhaust duct may not terminate underneath the mobile home. See Exhausting section for more information. EXHAUSTING Exhausting the dryer to the outside will prevent large amounts of lint and moisture from being blown into the room. In the United States: • All dryers must be exhausted to the outside. • The required exhaust duct is 4inch(102mm) in diameter. • Only those foil-type flexible ducts, if any, specifically identified for use with the appliance by the manufacturer and that comply with the Outline for Clothes Dryer Transition Duct, Subject 2158A, shall be used. • The duct shall not be assembled with screws or other fastening means that extend into the duct and catch lint. In Canada: • Only those foil-type flexible ducts, if any, specifically identified for use with the appliance by the manufacturer shall be used. • All dryers must be exhausted to the outside. • The exhaust duct should be 4inch (102mm) in diameter. Outside the U.S. and Canada: • Refer to the local codes. The dryer must be exhausted to the outside to reduce the risk of fire when installed in an WARNING alcove or closet. NEVER USE A PLASTIC OR NON-METAL FLEXIBLE DUCT. If your existing ductwork is plastic, non-metal, or combustible, replace it with metal. Use only a metal exhaust duct that is non-flammable to ensure containment of exhaust air, heat, and lint. DV520AE-02836A_EN.indd 13 installing your dryer _13 2010-04-13 ¿ÀÈÄ 4:29:30
![](/manual_guide/products/samsung-dv520aepxaa-user-manual-user-manual-ver10-english-813f50b/13.png)