Samsung DW80H9970US User Manual Ver.1.0 (English) - Page 11

03 using your dishwasher 10 Delay Start 11 Start Lack of salt indicator (*applicable models only) - Turns on when the water softener runs out of salt. (or the dishwasher is in the standby or pause modes.) - Turns off while the dishwasher is operating. Delay a cycle for up to 24 hours in one-hour increments. To increase the delay start time, press or hold the Delay Start button. The hour displayed indicates the time at which the wash will be started. - After setting the delay time, press the Start button, and then close the door to start the cycle. - If you want to change the delay time once the dishwasher has started, press the Reset button and turn off the dishwasher. Then, turn on the dishwasher again and select a new cycle with a new delay setting. To start a cycle, press the Start button before closing the door. *Reset : To cancel a currently running cycle and drain the dishwasher, press and hold the Start button for three (3) seconds. Once the dishwasher is reset, select a cycle and option, and then press Start to restart the dishwasher. You can select options (Self Clean, Upper, Lower, Speed Booster, Sanitize, Dry+, Delay Start) before starting a cycle. If you change the cycle after selecting an option, the original cycle is reset. To prevent the touchpad from losing response sensitivity, follow these instructions: - Touch the center of each keypad using one finger. Do not push. - Clean the touch control's surface regularly with a soft, damp cloth. - Be careful not to touch more than one touch key pad at a time, except as directed. When you pause a cycle by opening the door during operation, press the Start button before closing the door to continue the cycle. OO X DW80H9950-00149A_EN_140227.indd 11 English - 11 2014-02-27 4:15:29