Samsung DW80N3030 Series Installation Guide - Page 12
Preparing The Dishwasher
View all Samsung DW80N3030 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
rear STEP 6 PREPARING THE DISHWASHER 1. 2. Use the provided nut connector to connect the water hose to the dishwasher. Follow these steps: 1 2 3 A E CD B F 1) Disconnect the 90° fitting (A) from the hose (B). 2) Remove the seal (C) and the nut (D) from the 90° fitting. 3) From the provided nut connector, separate the seal (E) and the nut (F), and then assemble them to the 90° fitting as shown in the figure. You must insert the smaller side of the seal. 3. Then, insert the ¾" 90 degree fitting into the inlet valve (see Figure 4-B). Tighten until the ¾" fitting is tight. Do not over tighten.
rear
STEP 6
PREPARING THE DISHWASHER
1.
Use the provided nut connector to connect the water hose to the dishwasher.
Follow these steps:
1
2
3
A
B
C
E
F
D
1)
Disconnect the 90° fitting (A) from the hose (B).
2)
Remove the seal (C) and the nut (D) from the 90° fitting.
3)
From the provided nut connector, separate the seal (E) and the nut (F), and then
assemble them to the 90° fitting as shown in the figure. You must insert the smaller side
of the seal.
Then, insert the ¾" 90 degree fitting into the inlet valve (see Figure 4-B). Tighten until the ¾"
fitting is tight. Do not over tighten.
2.
3.