Samsung FE-N300WX User Manual (user Manual) (ver.1.0) (English) - Page 24

Using the touch control sensors To operate the touch control sensors, touch the desired panel with the tip of your pointed finger until the relevant displays illuminate or go out, or until the desired function is activated. Ensure that you are touching only one sensor panel when operating the appliance. If your finger is too flat on the panel, an adjacent sensor may be activated as well. If more than one touch sensor button is pressed for longer than 1 minute, will show in the heat setting display. To reset, touch the On/Off control sensor. How to set the appliance for cooktop cooking • The cooktop elements may be hot and burns may occur. Do not touch the surface CAUTION elements until they have cooled down sufficiently. • At high or over the 6 level, never leave food unattended. Boilovers cause smoke. Greasy spillovers may catch on fire. • Be sure you turn the Touch control to OFF when you finish cooking. Select cooking zone on 1. To switch on the cooking zone, touch On/Off control sensor. 2. The digital displays will show . After the On/Off control sensor has been activated to switch on your appliance, a heat setting must be selected within approximately 5 seconds. Otherwise, the appliance will switch itself off for safety reasons. Heat setting 1. Radiant Burner a. In the next 5 seconds, move your finger along the control panel until the desired heat level setting appears in the digital display. • Select the Low touch sensor for the lowest power level. • Select the Hi touch sensor for the highest power level. b. To set and adjust the power level from ( to ) for cooking, touch the Heat level setting selectors (+ or -). 24_ Surface cooking