Samsung HCN4226W User Manual (user Manual) (ver.1.0) (English) - Page 11

YOUR NEW TV Rear Panel Jacks (Depending on the model) Use the rear panel jacks to connect an A/V component that will be connected continuously, such as a VCR or a DVD player. Because there are two sets of input jacks, you can connect two different A/V components (i.e., a VCR and a DVD, 2 VCRs, etc.) For more information on connecting equipment, see pages 2.1 - 2.10. Œ ANTENNA terminals ˆ S-VIDEO INPUT jack Two independent cables or antennas can be Connect to an S-VHS VCR or DVD player. connected to these terminals. Use ANT-A and ANT-B terminals to receive a signal from VHF/ Ø COMPONENT 1(480i, 480p, UHF antennas or your cable system. 1080i) AUDIO/VIDEO INPUT Use the ANT-A OUT terminal to send the signal jacks being received by the ANT-A terminal out to Connect a source that outputs 480i/480p/1080i Y,PB another component (such as a Cable Set Top Box). and PR signals, such as a DVD (or DTV Set-Top Box. The PIP channel can be received only when a signal source is connected to ANT-A. ∏ DIGITAL INPUT (Digital ´ AUDIO-VIDEO MONITOR Visual Interface) jack Receives the digital video signals from a set top OUTPUT jacks box. (The DVI jack is not available on PCN5425R.) Connect to the audio/video input jacks of a recording VCR. " COMPONENT 2, 3(480p, Note: The monitor out does not operate 1080i) AUDIO/VIDEO INPUT in DVD or DTV mode. jacks ˇ VIDEO INPUT jacks Connect a source that outputs 480p/1080i Y, PB and PR signals, such as a DTV Set-Top Box. Connect to the video output jacks of VCRs, (Component3 jacks ; Depending on the model) DVD players and similar devices (Two sets are available: Video1 and Video2). ' DVI AUDIO INPUT jacks ¨ AUDIO INPUT jacks Receives the digital audio signals from a set top box. Connect to the audio output jacks of VCRs, DVD players and similar devices. 1.4 CHAPTER ONE: YOUR NEW TV