Samsung HT-DL70D Instruction Manual - Page 7

Connecting the FM and AM(MW/LW) Antennas 1 2 3 If AM reception is poor, connect an outdoor AM GB antenna(not supplied). If FM reception is poor, connect outdoor FM antenna (not supplied). ANTENNA AM Loop Antenna (supplied) FM Antenna (supplied) Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna. R-REAR-L WOOFER CENTER 6 3 6 SPEAKERS R-FRONT-L 6 SPEAKERS AV OUT Y/C AUX IN L COMP. R VIDEO S-VIDEO VIDEO OUT ANTENNAA AM Cooling fan (See "About Cooling Fan" below.) FM antenna connection 1. Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal. 2. Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface. • If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna. AM(MW/LW) antenna connection 1. Connect the AM loop antenna supplied to the AM and terminals. 2. If reception is poor, connect an outdoor single vinyl-covered wire to the AM terminal. (Keep the AM loop antenna connected). (About the cooling fan) A cooling fan is mounted on the rear panel of the center unit to For safety, observe the following carefully. prevent abnormal temperature inside the center unit, thus assuring normal operation. The cooling fan automatically starts rotating to supply external cool air to the inside of the center unit when the internal temperature exceeds the specified limit. • Make sure there is good ventilation around the center unit. Poor ventilation could overheat and damage the canter unit. • DO NOT block the cooling fan and the ventilation openings or holes. (If they are blocked by a newspaper or cloth, etc., the heat 11 may not be able to escape.) AUX Connections TV GB To view pictures from the external input (AUX), VIDEO IN first connect the VIDEO IN jack (VIDEO) and then connect the VIDEO OUT jack. R-REAR-L WOOFER CENTER 6 3 6 SPEAKERS R-FRONT-L 6 SPEAKERS AV OUT Y/C AUX IN L COMP. VIDEO S-VIDEO VIDEO OUT ANTENNAA AM R Audio Cable (Red/White) If the external analog component has only one output jack, you may connect either L or R. External Analog Components R L Connect to external equipment with analog outputs. Example: Video, TV, etc. • Always connect the video and audio connection cables to the equivalent colored jack. Making Analog Input Selection Remote Control Press the AUX button and select AUX IN. Main Unit Press the Function button and select AUX IN. 12