Samsung HT-WP38 Quick Guide (easy Manual) (ver.1.0) (English) - Page 9
Connecting Wireless Rear Speakers, Resetting Wireless Communication - remote control
View all Samsung HT-WP38 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Connecting Wireless Rear Speakers 1 Connect your pair of wireless rear speakers, (L) and (R), to the wireless receiver module. Wireless Rear Speaker (R) Wireless Rear Speaker (L) 2 Connect the power cord of the wireless receiver module to the wall outlet and turn the power "ON". • The Power Standby indicator will light up. Gray Blue Back of Wireless receiver module Caution • Do not connect the wireless rear speakers to the speaker outputs on the back of the main unit. Malfunction may result. • The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture. • For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions. To hang the wireless receiver module on the wall, 1 Separate wireless receiver module stand. 2 Fasten the screws on the wall. 3 Fix the wireless receiver Fit the speaker module hole onto the screw on the wall to hang on the wall. (mount) the speaker. • Fix the wireless receiver module firmly to prevent it from falling. 15 Note • Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main unit, some sound interruption may be heard due to interference. • If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference. • The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not operate at all because the radio wave cannot penetrate metal. Resetting Wireless Communication Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the "REAR CHK" message blinks on the main unit's display. Reset the system while the main unit and the wireless receiver module (SWA-2000) are in Power Standby mode. ENG CONNECTIONS 1 With the main unit turned off, press and hold the remote control's REMAIN button for 4 seconds. • Press the button until the volume control indicator lights up blue. (The indicator will turn off in 1 second.) RESET Button 2 With the wireless receiver module turned on, use a ball point pen or a pair of tweezers to press the RESET button on the back of the unit 2 to 3 times. • The Standby/On LED on the front panel of the wireless receiver module blinks 3 times. Back of Wireless receiver module 3 Turn on the main unit. • The Link LED of the wireless receiver module is lit and the setup is finished. • If Power Standby mode continues, repeat Steps 1 to 3 above. Caution • Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only. • In 2-CH mode, no sound will be heard from the wireless rear speakers. 16