Samsung HW-Q700B/ZA User Manual - Page 17

LED Indicator Lights on the Rear of Subwoofer and Surround Speakers LED Subwoofer Status On Description Successfully connected (normal operation) Resolution Blue Surround Speakers (applicable models only) Blue Subwoofer Red Surround Speakers (applicable models only) Blinking Recovering the connection Check if the power cable attached to the main Soundbar unit is connected properly or wait about 5 minutes. If blinking persists, try manually connecting the subwoofer and Surround Speakers. See page 16. Standby (with the Soundbar main unit turned off) Check if the power cable attached to the main Soundbar unit is connected properly. On Connection failed Connect again. See the instructions for manual connection on page 16. Red Subwoofer Red and blue Surround Speakers (applicable models only) Blinking Malfunction See the contact information for the Samsung Service Center in this manual. Red and blue NOTE • If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will turn red after blinking in blue several times. • If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption. • The maximum transmission distance of the main unit's wireless signal is about 32.8 ft (10 m), but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the wireless signal cannot penetrate metal. • The surround speaker system is supported by applicable models only. CAUTION • Wireless receiving antennas are built into the wireless subwoofer and Surround Speakers. Keep the unit away from water and moisture. • For optimal listening performance, make sure that the area around the wireless subwoofer and the Surround Speakers are clear of any obstructions. ENG - 17