Samsung HW-Q70T/ZA User Manual - Page 18

LED Indicator Lights on the Rear of Subwoofer LED Blue Red Red and blue Status On Blinking On Description Successfully connected (normal operation) Recovering the connection Standby (with the Soundbar main unit turned off) Connection failed Resolution - Check if the power cable attached to the main Soundbar unit is connected properly or wait about 5 minutes. If blinking persists, try manually connecting the subwoofer. See page 16. Check if the power cable attached to the main Soundbar unit is connected properly. Connect again. See the instructions for manual connection on page 16. Blinking Malfunction See the contact information for the Samsung Service Center in this manual. NOTES •• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will turn red after blinking in blue several times. •• If you use a device that uses the same frequency (5.8GHz) as the Soundbar near the Soundbar, interference may cause some sound interruption. •• The maximum transmission distance of the main unit's wireless signal is about 32.8 ft (10 m), but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the wireless signal cannot penetrate metal. CAUTION •• Wireless receiving antennas are built into the wireless subwoofer. Keep the unit away from water and moisture. •• For optimal listening performance, make sure that the area around the wireless subwoofer and the Wireless Receiver Module (sold separately) is clear of any obstructions. ENG - 18