Samsung HW-S800B/ZA User Manual - Page 30

10 SOFTWARE UPDATE Auto Update When the Soundbar is connected to the Internet, software updates automatically occur even when the Soundbar is turned off. • To use the Auto Update function, the Soundbar must be connected to the Internet. The Wi-Fi connection to the Soundbar will be terminated if the Soundbar's power cord is disconnected or the power is cut off. If the power is cut off, when the power comes back on or you reconnect the power cord, turn on the Soundbar, and then reconnect it to the Internet. USB Update Rear of the Soundbar SERVICE SERVICE HDMI (ARC) HDMI (ARC) Micro USB to USB adapter Cable (not supplied) Samsung may offer updates for the Soundbar's system firmware in the future. When an update is available, you can update the Soundbar by connecting the USB drive that contains the update firmware to the SERVICE port of the Soundbar. 1. Go to (www.samsung.com) → search for the model name from the customer support menu option. • For more information about update, refer to Upgrade Guide. 2. Download the upgrade file (USB type). 3. Unzip the file to create a folder with the file name. 4. Store the created folder in a USB and then connect it to the Soundbar. 5. Turn on the Soundbar. Then the product is updated within 3 minutes. LED indicator White moves from left to right and right to left • If there is no update file available, the indicator blinks red 3 times. LED indicator Red Blinks X3 • If the update file is in the same or lower version than the existing, the indicator blinks cyan 3 times. LED indicator Cyan Blinks X3 Reset 5 Sec With the Soundbar on, press the (Volume) buttons on the body at the same time for at least 5 seconds. The LED display changes as shown below and then the Soundbar is reset. White moves from left to right and right to left LED indicator Cyan Blinks X3 Red Blinks → Off CAUTION • All the settings of the Soundbar are reset. Be sure to perform this only when a reset is required. • During update, do not turn it off or remove the USB. • If the yellow LED is on after the software update is completed, this means that an additional update is in progress. When this happens, don't turn off the power or remove the USB. • If update does not proceed, reconnect the Soundbar power cord. • When the latest version is installed, no update is performed. • Depending on the USB type, update may not be supported. ENG - 30