Samsung LU28E570DS/ZA User Manual - Page 33
Eco Saving Plus, Off Timer, PC/AV Mode, DisplayPort Ver., Source Detection
View all Samsung LU28E570DS/ZA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Eco Saving Plus PC/AV Mode Reduce energy consumption compared to consumption at the maximum brightness level. ――This option is not available when MSAMASGUNICGBright is in Dynamic Contrast mode. ――This menu is not available when Game Mode is enabled. ――This menu is not available when Eye Saver Mode is enabled. ――Not available when PIP/PBP Mode is set to On. •• Off: Deactivate the Eco Saving Plus function. •• Auto: The power consumption will automatically be reduced by about 10 % over the current setting. (The reduction of power consumption depends on the customer screen brightness condition.) •• Low: Saves up to 25 % energy compared to the maximum brightness. •• High: Saves up to 50 % energy compared to the maximum brightness. Set PC/AV Mode to AV. The picture size will be enlarged. This option is useful when you view a movie. •• Set to PC when connected to a PC. •• Set to AV when connected to an AV device. ――Supplied for the wide models only such as 16:9 or 16:10. ――If the monitor (when set to HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is displaying the message Check Signal Cable, press the MENU button to display the On Screen Display(OSD). You can select PC or AV. DisplayPort Ver. Off Timer Off Timer: Turn on Off Timer mode. Turn Off After: The off timer can be set within a range of 1 to 23 hours. The product will automatically power off after the specified number of hours. ――This option is only available when Off Timer is set to On. ――For products for the market in some regions, the Off Timer is set to automatically activate 4 hours after the product powers on. This is done in accordance with power supply regulations. If you do not want the timer to activate, go to MENU System and set Off Timer to Off. Select your Displayport. Displayport 1.1 supports High Bit Rate 1, while 1.2 supports High Bit Rate 2. ――Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications. ――If the monitor (when set to HDMI 1, HDMI 2 or DisplayPort) is in power saving mode or is displaying the message Check Signal Cable, press the button to display the On Screen Display (OSD). You can select 1.1 or 1.2. ――If you select 1.1, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1 transmission speeds. Source Detection ――Not available when PIP/PBP Mode is set to On. Select either Auto or Manual as the method to recognize input signal. 33