Samsung ML 3050 User Manual (ENGLISH) - Page 48
Understanding display messages, LSU Hsync Error
View all Samsung ML 3050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Understanding display messages Messages appear on the Smart Panel program window or the control panel display to indicate the printer's status or errors. Refer to the tables below to understand the messages' meaning and correct the problem if necessary. Messages and their meanings are listed in alphabetical order. Note When you call for service, it is very convenient to tell the service representative the display message. Message Meaning Suggested solutions Door Open The front cover or rear cover is not securely latched. Close the cover until it locks into place. Duplex Jam 0 Check Inside Paper has jammed during duplex printing. Clear the jam. See page 9.4. Duplex Jam 1 Open/ Close Door Paper has jammed during duplex printing. Clear the jam. See page 9.5. Fuser Door Open Load Manually Press Stop Key The fuser door is not securely latched. The multi-purpose tray is empty in manual feed mode. Open the rear cover and close the fuser door until it locks into place. For the location of the fuser door, see page 9.4. Load a sheet of print material and press Stop. Low Heat Error Cycle Power There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. LSU Hsync Error Cycle Power A problem has occurred in the LSU (Laser Scanning Unit). Unplug the power cord and plug it back inches. If the problem persists, please call for service. LSU Motor Error Cycle Power A problem has occurred in the LSU (Laser Scanning Unit). Unplug the power cord and plug it back inches. If the problem persists, please call for service. Message Meaning Suggested solutions Main Motor Locked There is a problem in the main motor. Open and then close the front cover. Open Heat Error Cycle Power There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. Over Heat Error Cycle Power There is a problem in the fuser unit. Unplug the power cord and plug it back in. If the problem persists, please call for service. Paper Jam 0 Open/Close Door Paper has jammed in the feeding area of the tray. Clear the jam. See page 9.1 and page 9.1. Paper Jam 1 Open/Close Door Paper has jammed in the fuser area. Clear the jam. See page 9.3. Paper Jam 2 Check Inside Printing... Ready Paper has jammed in the paper exit area. The printer is printing jobs using the displayed language. The printer is on-line and ready to printer. Clear the jam. See page 9.3. Complete your printing. Use your printer. Self Diagnostic... Sleeping... The engine in your printer is checking some problems detected. The printer is on power save mode. Please wait a few minutes. When data is received, it switches to on-line automatically. Tray 1 Paper Empty There is no paper in Load paper in the the tray 1. tray 1. See page 5.5. Tray 2 Paper Empty There is no paper in the optional tray 2. Load paper in the optional tray 2. See page 5.5. 9.7