Samsung ML2152W User Manual (ENGLISH) - Page 154

Problem Possible Cause and Solution I have CUPS and some options (such as N-up) seem to be always enabled even though I don't pick them in LLPR. There may be some local options defined in your ~/.lpoptions file, which is manipulated by the lpoptions command. These options will always be used if not overridden by LLPR settings. To get rid of all options for a printer, run the following command, replacing "printer" with the name of the queue: lpoptions -x printer I configured a printer to print to a file, but I get "Permission denied" errors. Most printing systems will not run as the super-user but as a special user (usually "lp"). Therefore, make sure that the file you have chosen to print to is accessible to the user owning the spooler daemon. On my PCL (or SPL) printer, I sometimes get error messages printing instead of my document. Unfortunately, some Unix applications may generate noncompliant PostScript output that may not be supported by Ghostscript, or even the printer itself in PostScript mode. You can try to capture the output to a file and view the results with Ghostscript (gv or ghostview will allow you to do so interactively) and see if you get error messages. However, since the application is at probably fault, contact your software vendor to inform them of the issue. Common DOS Problem Problem 7 Possible Cause and Solution When using the printer in EPSON Dot Printer Environment, sometimes I can not get the output I want. Change the emulation to EPSON in the Config tab in the Remote Control Panel. For detailed information about selecting printer settings in the Remote Control Panel, see page D.4. SOLVING PROBLEMS 7.27