Samsung MZ-5PA064 User Manual - Page 9

Using the DOS SSD Firmware Utility, Starting DOS SSD Application

Get Samsung MZ-5PA064 PDF manuals and user guides
UPC - 036725650008
View all Samsung MZ-5PA064 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Chapter 2 Using the DOS SSD Firmware Utility IMPORTANT: The following section assumes that DOS SSD FWD UTIL has been properly installed. Before proceeding, be sure to: š Successfully complete the entire DOS SSD FWD UTIL installation process as instructed in the "Setting Up and Configuring Your System" on page 2 section Starting DOS SSD Application The DOS SSD application is launched from the USB. [Warning]: DOS SSD FWD UTIL will execute only in IDE/ATA or AHCI mode. Please check the BIOS setting and set drive mode/ configuration to Native/Compatible/Legacy/AHCI modes. © 2010 Samsung Electronics 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
© 2010 Samsung Electronics
5
Chapter 2
Using the DOS SSD Firmware
Utility
IMPORTANT:
The following section assumes that DOS SSD FWD UTIL has been
properly installed. Before proceeding, be sure to:
±
Successfully complete the entire DOS SSD FWD UTIL installation
process as instructed in the
“Setting Up and Configuring Your
System” on page 2
section
Starting DOS SSD Application
The DOS SSD application is launched from the USB.
[Warning]: DOS SSD FWD UTIL will execute only in IDE/ATA or AHCI
mode. Please check the BIOS setting and set drive mode/
configuration to Native/Compatible/Legacy/AHCI modes.