Samsung NX60A6511SS/AA User Manual - Page 10

Important safety information Important safety information Installation safety WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. • Have your range installed and properly grounded by a qualified installer, in accordance with the installation instructions. Any adjustment and service should be performed only by qualified gas range installers or service technicians. • Do not attempt to service, modify, or replace your range or any part of your range unless it is specifically recommended in this manual. All other service should be referred to a qualified technician. • Always use new flexible connectors when installing a gas appliance. Do not use old flexible connectors. • Make sure the Anti-Tip device is properly installed on the range. See the installation instructions for more information. • Due to the size and weight of the range, have two or more people move the range. • Remove all tape and packaging materials. • Remove all accessories from the cooktop, oven, and/or lower drawer. Grates and griddles are heavy. Use caution when handling them. • Make sure no parts came loose during shipping. Do not install in an area exposed to dripping water or outside weather conditions. • Make sure your range is correctly installed and adjusted by a qualified service technician or installer for the type of gas (natural or LP) you will use. For your range to utilize LP gas, the installer must replace the 5 surface burner orifices and 2 oven orifices with the provided LP orifice set, and reverse the GPR adapter. These adjustments must be made by a qualified service technician in accordance with the manufacturer's instructions and all codes and requirements of the authority having jurisdiction. The qualified agency performing this work assumes the gas conversion responsibility. • Installation of this range must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must conform with the current Natural Gas Installation Code, CAN/CGA-B149.1, or the current Propane Installation Code, CAN/CGA-B149.2, and with local codes where applicable. This range has been design-certified by ETL according to ANSI Z21.1, latest edition, and Canadian Gas Association according to CAN/CGA-1.1, latest edition. Location safety WARNING To reduce the risk of fire, electric shock, personal injuries, and/or death, observe the following precautions. • This range is for indoor, household use only. Do not install the range in areas exposed to the weather and/or water. • Do not install the range in a place which is exposed to a strong draft. • Select a level, well-constructed floor that can support the range's weight. Synthetic flooring, such as linoleum, must withstand 180 °F (82 °C) temperatures without shrinking, warping, or discoloring. Do not install the range directly over interior kitchen carpeting unless a sheet of ¼ inch plywood or a similar insulator is placed between the range and carpeting. • Select a location where a grounded, 3-prong outlet is easily accessible. • If the range is located near a window, do not hang long curtains or paper blinds on that window. • Do not block or cover the vents (air openings) located at the rear of the range and at the top and bottom of the door. The vents allow for air circulation that is necessary for the range to operate properly with correct combustion. Blocking or covering the vents may cause incorrect combustion which could result in gas leaks and fire. 10 English