Samsung RB10FSR4ESR/AA User Manual - Page 17
Flooring
View all Samsung RB10FSR4ESR/AA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
01 SETTING UP 01 03 03 05 Model 01 02 03 04 05 02 04 RB10* more than 2" (50 mm) recommended 135° at least 2" (50 mm) 39 1/8" (994mm) 47 6/8" (1212mm) Spacer Spacer • Please ensure that appliance can be moved freely in the event of maintenance & service. CAUTION When installing, servicing, or cleaning behind the refrigerator, be sure to pull the unit straight out and push back in straight after finishing. Also, make sure your floor supports the full-load refrigerator. Otherwise, it may cause floor damage. CAUTION Please tie up the extra length of the power cord at the back of the refrigerator so as not to be touched on the floor preventing the power cord from being crushed by the rollers upon relocation. FLOORING For proper installation, this refrigerator must be placed on a level surface of hard material that has the same height as the rest of the flooring. This surface should be strong enough to support a fully loaded refrigerator (or approximately 65 kg).To protect the floor finish, cut a large section of the cardboard carton and place it under the refrigerator where you are working. • Remove paper on spacer and then attach a spacer (Gray block) on the back side of refrigerator for better performance. Make sure a spacer fix like above image when you install the refrigerator. It is improving the refrigerator performance. (Only for A+++ energy grade models) • Pulling or pushing the refrigerator may damage the floor. Moving the refrigerator after installation may damage the floor. • Allow sufficient space to the right, left, back and top for air circulation. This will help reduce power consumption and keep your energy bills lower. • Do not install the refrigerator where the temperature will go below 10 °C (50 ºF). setting up _17