Samsung RF260BEAESP User Manual Ver.1.0 (English, French, Spanish) - Page 7
Accessories And, Required Tools, Removing The, Refrigerator Doors
View all Samsung RF260BEAESP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
01 setting up FLOORING For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 331lbs (150kg). To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side. Removing the refrigerator doors For some installations you need to remove the fridge and freezer drawers so you can move the refrigerator to its final location. Do not remove the doors/drawer if you don't need to. If you do not need to remove the refrigerator doors, go to Adjusting the Level on page 9. If you need to remove the doors. continue below. Before removing the door/drawer, make sure you read the following items: Disconnect power to the refrigerator before WARNING removing the door or drawer. Accessories and required tools The following accessories are included with your refrigerator: •• Be careful not to drop, damage or scratch the door/drawer while removing them. •• Be careful not to get injured while removing the door/drawer. •• Reattach the door/drawer properly to avoid: -- Moisture from air leakage. -- Uneven door alignment. -- Wasting energy due to improper door seal. Disassemble the refrigerator doors Be careful not to drop and scratch the WARNING doors while removing the doors. With the door opened 111 Remove 3 screws holding down the TOP TABLE ( 1 ) and turn it with wires connected. Hex wrench Fastener 1 Required Tools (Not provided) You need the following tools to complete the installation of your refrigerator: Philips Flat-blade screw Socket wrench screwdriver(+) driver(-) (10mm) 222 Disconnect two connector ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge. 2 Pliers Allen wrench (3/16") (5mm) setting up _07 DA68-02601B(EN+ES+FR)-0.0.indb 7 2012.3.29 9:28:31 AM