Samsung RF323TEDBWW User Manual Ver.1.0 (English, French, Spanish) - Page 14

5. Touch the "Alarm/hold 3 sec for Filter Reset" button ( ) for about (Filter Reset) 3 seconds to reset the water filter. The color of the indicator ( ) changes from red to off. 6. If you turned off the water supply, turn it back on. For a replacement water filter, you can visit your local home Improvement center or contact the Samsung Parts distributor. Be sure the replacement water filter has the SAMSUNG logo on the box and on the water filter. Link : http://www. samsungparts.com Removing any residual matter inside the water supply line after installing the water filter. 1. Turn ON the main water supply and supply water from water supply line. 2. Run water through the dispenser until the water runs clear (approx. 6 to 7 minutes). This will clean the water supply system and remove air from the lines. 3. Additional flushing may be required in some households. 4. Open the Refrigerator door and make sure there are no water leaks coming from the water filter. • Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary. • Allow the storage tank on the reverse osmosis system to refill after heavy usage. • If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter. If you have questions about your water pressure, call a licensed, qualified plumber. CONTROLLING THE TEMPERATURE Basic temperature of Freezer and Refrigerator Compartments The basic temperature and recommended temperatures of the Freezer and Refrigerator Compartments are 0°F and 37°F (or -18°C and 3°C) respectively. If the temperature of the Freezer and Refrigerator Compartments are too high or low, adjust the temperature manually. Controlling the Freezer temperature Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser. This means that there is still air in the line. Reverse Osmosis Water Supply IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa). If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.) If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa): 14_ operating Recommend Temp (Freezer) : 0°F (or -18°C ) The Freezer temperature can be set between -8°F and 5°F (or between -23°C and -15°C) to suit your particular needs. Press the Freezer button repeatedly until the desired temperature is shown in the temperature display. The temperature will change by 1°F (or 1°C) with each press. See below. Fahrenheit : 0°F ➞ -1°F ➞ -2°F ➞ -3°F ➞ -4°F ➞ -5°F ➞ -6°F ➞ -7°F ➞ -8°F ➞ 5°F ➞ 4°F ➞ 3°F ➞ 2°F ➞ 1°F ➞ 0°F. Centigrade : -18°C ➞ -19°C ➞ -20°C ➞ -21°C ➞ -22°C ➞ -23°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ -18°C. Keep in mind that foods like ice cream may melt at 4°F (or -15.5°C). The temperature display will %""JOEC


 1.